![]() For vinyl and HTV increase the default blade depth from 1 to 2.ĭo a few test cuts and if you are still not getting good cuts, increase the force slowly. Once the software is updated, plug in and power on your machine and in the Send panel you'll be promoted to do a firmware update, if one is availableįinally, if all of these checks are okay - you can move to adjusting the cut settings. Do this by updating to the most current version of the Silhouette Studio software. ![]() Check if there is a firmware update needed.Power the machine back on so it resets the carriage position. Power the machine off and move the blade carriage back and forth three times.Remove the white cap and make sure there's no debris inside the blade cap that's preventing the blade from fully tapping.Try these three fixes to get the auto blade depth adjustment working again: This is usually caused by an issue with the tapping which is how the blade depth is auto adjusted. ![]() If the blade depth line is not moving it means the blade depth is not being adjusted.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |